Partsch Periodontal Instruments

Description

Partsch Periodontal Instruments

Named after the German oral surgeon Carl Partsch, the partsch periodontal elevator is a short pattern for flap work. Ours is 14.5 cm long. The supplier lists it on the same catalogue page as the Konig and Freer elevators. Because there is just one Partsch entry, you do not need to pick a size or variant.

A Shorter Elevator for Close Work

At 14.5 cm, this Partsch is the more compact of our two European elevators. That shorter body keeps your fulcrum close to the site. As a result, many clinicians like it for incisor and premolar flaps, where fine control matters more than reach. For molar areas, the 15.5 cm Konig gives a touch more length.

Typical Steps With the Partsch

First, the blade enters the sulcus or incision line. Next, it sweeps under the periosteum and lifts the flap from the bone in one layer. Then the same end can hold the tissue aside while you inspect a defect or a root. It also loosens the attached gingiva around a tooth before a surgical extraction.

How Each Partsch Reaches You

The Partsch is surgical stainless steel, and our staff look over each one in the United States before dispatch. It comes out of the packet unsterilized, so clean it and run a full steam cycle first. Should a flaw show up in the Partsch 14.5 cm steel, it stays protected for three years against manufacturing defects under our own policy.

We source the steel to the ASTM F899 standard. Other flap and bone tools sit in our Maxillofacial Surgery Instruments range. Many buyers add the Williger periodontal instruments beside the partsch periodontal elevator, and our FAQs handle common order questions.

Intended only for trained clinicians in a dental or surgical setting. Read our instrument care notes and delivery information for the Partsch before you order.